DESCRIPTION OF THE PROJECT
Pumping chemical emulsion with small inclusions. Productivity of the pump is 25 m3/hour.
According to the tasks set, the BN076L01FY pump was selected. For this model of the pump, the maximum allowable speed was selected for the safe pumping of products, which ensured the desired pump productivity. SOLTEC ® specialists produced an integrated stator, which allows, according to the degree of rubber wear, to restore the desired performance and maximize the life of the rubber.
Technical details of screw pump BN076L01FY:
- Pump type - horizontal
- Wet end material – AISI 304 steel
- Maximum outlet pressure - 6 bar
- Productivity - 25 m3/hour
- Rotor speed - 167 rpm
- Inlet/outlet to the pump - flange DN 150
- Drive shaft seal type - single mechanical seal
- Motor specifications - 15 kW, 380 V, IP55
300 Spectrum Center Drive #400, Irvine, CA 92618
V.E.P. Baumaschinen GmbH
"SOLTEK NMZ", TOO