Single screw horizontal progressing cavity pump unit SOLTEC ® BN125S02HYYXT for transferring of crude oil content

progressive cavity pumps soltec foto 1 progressive cavity pumps soltec foto 2 progressive cavity pumps soltec foto 3 progressive cavity pumps soltec foto 4 progressive cavity pumps soltec foto 5 progressive cavity pumps soltec foto 6

TASK: Oil producing company has set the request for pumping equipment for crude oil with the following parameters: capacity 80 m3/h and working pressure up to 12 bar, the needed number of pumps is 4 pieces.

SOLUTION: SOLTEC ® specialists designed and manufactured horizontal single-screw pumps BN125S02HYYXT equipped with STROINA cylindrical gearboxes. As part of the requirements for explosion safety, each screw pump is equipped with an explosion-proof electric motor 1ExdIIBT4. Accordingly to the API requirements, the pumps are equipped with a double mechanical seal with a flushing tank and sensors accordingly to the Plan 52. Also, pump units are equipped with a protection against "dry running".

The main characteristics of the screw pump unit BN011S02FYN:

  • Pump type - horizontal single-screw pump
  • The material of the flow part is AISI 304 general industrial steel
  • The material of the screw (rotor) is AISI 321 stainless steel
  • The material of the stator is oil resistant rubber NBR
  • Maximum outlet pressure - up to 12 bar
  • Capacity - 80 m3/h
  • Speed of drive shaft rotation - 220 rpm
  • Seal type of the drive shaft - double mechanical with additional flushing and sensors accordingly to the API Plan 52
  • Engine in explosion proof industrial design 1ExdIIBT4, IP55, У1
  • Equipped with gear reducer STROINA
CONTACT US
SOLTEC NMZ, LLC

International Sales Department

 +380 93 803 43 48
 +380 67 830 01 00

 office@soltecpumps.com