PROGRESSIVE CAVITY PUMPS

The basis of any Progressive Cavity Single Screw Pump is a power section which usually consists of a metal rotor (n-start external helix) and a rubber stator (n+1-start internal helix). Rotation of the rotor inside the stator creates sealed cavities that progressively move from suction to discharge side of the pump producing differential pressure.

Home > Our Projects > Single screw progressing cavity pump unit SOLTEC ® BV090S03HYX for pumping of oil and water emulsion
Галерея

OBJECTIVE: Oil processing company requested pump equipment for the periodic transfer of water-oil emulsion from underground tank that has a volume a 100 m3. The needed pumping capacity is 40 - 50 m3/h with the pressure from` 0.3 to 1.6 MPa. The liquid viscosity is from 200 to 800 cSt.

SOLUTION: According to the technical requirements has been designed and manufactured the big volume vertical submersible pump SOLTEC ® BV090S03HYX.

The main characteristics of the screw pump unit BV090S03HYX

  • Pump type - vertical semi-submersible single-screw
  • The material of the flow part is carbon steel with protective coating
  • The material of the stator is oil resistant rubber SOLTEC ® NBR-1294
  • Maximum outlet pressure - up to 16 bar
  • Nominal capacity - 50 m3/h
  • Seal type of the drive shaft - single mechanicalEngine power - 37 kW
  • Engine explosion proof level - 1ExdIIBT4
  • Equipped with cylindrical with gear reducer STROJNA
  • Length of the submersible part - 4100 mm